Aquaplaning
Aquaplaning is loss of road holding (traction and steering capabilities) caused by tires skimming over the surface of a wet track.
It occurs when a tire's tread pattern is unable to disperse sufficient water from the road surface. Levels of traction (and therefore control) decrease as the size of the contact patch decreases. Aquaplaning causes the tire(s) to lose contact with the road, making the vehicle uncontrollable.
Aquaplaning is the effect of a loss of steering control and traction caused by a film of water building between the tire and road surface.
Most drivers will, at some stage, experience this effect to varying degrees. As the tire travels in a forward direction it relies mainly on the tread pattern to "evacuate" water from the road surface to enable a contact with the tires tread pattern. Several factors can affect the resistance of a tire to aquaplaning such as vehicle speed, depth of water, tire pressures and, most importantly, the tread depth of the tires.
In wet weather, the racing tires that have been properly designed and are in good running condition can cut through the water and maintain contact with the road at high speeds. In cases where the wet racing tires are excessively worn (bald tires) or underinflated, or the water is very deep, you may still aquaplane at slower speeds.
| Water depth: 5mm, new tires | ||||
|---|---|---|---|---|
| Diving speed | 20 km/h | 60 km/h | 80 km/h | 100 km/h |
| Ground contact surface photo |  |
|||
Tire fully in contact with ground |
Tire almost fully in contact with ground |
Tire is partialy floating up |
Almost all tire is floating on water layer |
|
| Speed: 80 km/h, Water depth: 5mm | |||
|---|---|---|---|
| Tire Groove deepth | New - 7.5 mm | 3,2 mm | 1.6 mm |
| Ground contact surface photo |  |
||
Tire is partialy floating up |
Much of the tire is floating up |
Almost all tire is floating on water layer |
|
At higher speeds, the wedge of water in front of the tires may pass under the tires and the tires will ride on a cushion of water resulting in possible complete loss of traction.
A) Sinkage zone: water forms a wedge that lifts the tread - no contact
B) Transition zone - partial contact
C) Contact zone - the tread is in contact with the ground
In the F1 Racing, there is a specific tire used for a very wet track during heavy rain, intermediate tires for wet track or light rain, compared to a dry one with no groves.
Rain tires are very heavily grooved and the angle of these grooves is set to give the best water evacuation and the best wet performance possible at very high speeds.
 |
||
|---|---|---|
Bridgestone Potenza slick tires for dry track |
Bridgestone Potenza Intrmediate tires for light rain |
Bridgestone Potenza full wet tires |
